PVD-00B-14P Main Pump For Kubota Excavator U15 U17 Hydraulic pump

Installing the main hydraulic pump on an excavator is a critical task that requires careful attention to detail to ensure proper operation and longevity of the hydraulic system. Below is a comprehensive notice outlining the key steps and considerations for installing the main pump.

Personal Protective Equipment (PPE): Always wear appropriate safety gear, including gloves, goggles, and a hard hat.
Disconnect Power: Before starting the installation, ensure that the excavator is turned off, the battery is disconnected, and the hydraulic system is depressurized to prevent accidental operation.
Tools and Materials Needed
New main hydraulic pump
Gaskets or O-rings (if applicable)
Hydraulic fluid
Wrenches and sockets
Torque wrench
Screwdrivers
Clean rags
Inspection mirror (optional)
Safety gear
Installation Steps

Read the Manual: Review the excavator’s service manual for specific instructions related to the main pump installation, including torque specifications and any special procedures.
Gather Tools and Parts: Ensure you have all necessary tools and replacement parts ready before starting the installation.

Drain Hydraulic Fluid: If necessary, drain the hydraulic fluid from the system to prevent spills during the removal process.
Disconnect Hoses and Lines: Carefully disconnect hydraulic hoses and lines from the old pump. Use appropriate tools to avoid damaging fittings.
Remove Mounting Bolts: Use a wrench to remove the mounting bolts securing the old pump to the engine or hydraulic system. Carefully lift the old pump out of its mounting position.

Clean the Mounting Surface: Thoroughly clean the mounting surface where the new pump will be installed. Remove any old gasket material or debris to ensure a proper seal.
Check for Damage: Inspect the surrounding components for any signs of wear or damage that may need to be addressed before installing the new pump.

Position the New Pump: Carefully position the new main hydraulic pump in place, aligning it with the mounting holes.
Install Gaskets or O-rings: If applicable, install new gaskets or O-rings to ensure a proper seal between the pump and the mounting surface.
Secure the Pump: Insert and hand-tighten the mounting bolts. Use a torque wrench to tighten the bolts to the manufacturer’s specified torque settings, ensuring even pressure across the pump.

Attach Hoses: Reconnect the hydraulic hoses and lines to the new pump, ensuring that they are properly secured and free of leaks.
Check for Proper Routing: Ensure that hoses are routed correctly to avoid kinks or damage during operation.

Refill the System: If hydraulic fluid was drained, refill the hydraulic system with the appropriate type and amount of hydraulic fluid as specified in the service manual.
Check for Leaks: Before starting the excavator, inspect all connections for leaks.